Assembly - Craftsman 25cc - Propane Curved Shaft Trimmer Powered by Lehr Operation Manual

ASSEMBLY

INSTALLING CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment
shield on your unit is not installed. Use only the
instructions that apply to the type of shaft and shield
that your unit is equipped with.
FOR CURVED SHAFT TRIMMERS
Place the cutting attachment shield and spacer against
tube as shown in (Fig. 1). Use the 2 screws provided
to clamp the cap and shield onto the tube. Tighten the
screws evenly. Make sure the shield does not touch
any rotating parts.
Spacer
Cap
Washer
Attaching Screws
FOR STRAIGHT SHAFT TRIMMERS
Place the cutting attachment shield onto the shaft
mount. Install using provided hardware in the sequence
as shown (Fig.2).
Shaft Mount
Plate Washer
Washer
Lock W asher
Attaching Screws
Cutting Attachment Shield
Fig. 1
Cutting Attachment Shield
Fig. 2
INSTALLING THE D-HANDLE AND LOWER HANDLE
STRAIGHT SHAFT AND ACCESSORY READY
TRIMMERS
1.Locate the 4 screws included in the tool kit.
2.Assemble the upper and lower handle parts and 4
screws as shown in (Fig. 3), positioning the handle
parts evenly over the rubber sleeve on shaft. Do not
completely tighten.
3.While holding the unit in the operating position (Fig.
14), position the D-handle to the location that pro -
vides you the best grip.
4.Tighten the clamp screws evenly, until the D-Handle
is secure.
Attaching
Screws
Lower Handle
Fig. 3
CURVED SHAFT TRIMMERS
1. Installing the D-Handle (non detachable model).
2. Installing D-Handle over the tube in desired position.
3. Install the fasteners as shown (Fig. 4).
4.Tighten until D-Handle is secure.
D-Handle
Fasteners
Fig. 4
WARNING:
To prevent serious injury, never operate the
trimmer without the cutting attachment in
place.
LEHR |
ALL RIGHTS RESERVED 2008-2009
D-Handle
5