6. Separate Heat Roller Ass'y after remove six
screws and after removing 6 screws as shown
in below, take out the heat roller assembly in
direction of the arrow while pulling the both side
of the unit-brush
Heat Roller
Caution : • Be careful not to damage or contaminate the sur-
face of the roller when assembling/disassembling
the heat roller.
• Additional state: Be careful especially not to dam-
age the covering of the fusing assembly.
(If the cover is damaged, it could cause an electric
leakage.)
Samsung Electronics
Fuser Cover
Unit-Brush
Disassembly and Reassembly
7. Unplug Thermister Harness from the Fuser
cover.
Thermister Harness
8. Remove one screw and separate Thermister
from the inter connector Fuser Cover.
Thermister
Service Manual
5-5