Installing Memory Module (Main Memory) - Toshiba Tecra M2 User Manual

Optional Devices
Use only memory modules approved by TOSHIBA.
Do not try to install or remove a memory module under the following
conditions. You can damage the computer and the module. Also, data
will be lost.
a.The computer is turned on.
b.The computer was shut down using the Standby mode or Hibernation
c.Wake-up on LAN is enabled.
If you install a memory module that is not compatible with the computer,
beep will sound when you turn on the power. If the module is installed in
slot A, there will be a long beep (1 second) followed by two short beeps (0.5
second each). If the memory module is in slot B, there will be a long beep
followed by four short beeps. If the both memory modules in slot A and slot
B are incompatible, there will be a long beep followed by two short beeps
and after a pause (1 second) a long beep followed by four short beeps. In
this case, shut down the power and remove the incompatible module(s).
Be sure to install memory module to Slot A. The computer does not boot
when Slot A is vacant.
Use a size 0, Phillips screwdriver to remove and fasten screws. Use of an
incorrect screwdriver can damage the screw heads.

Installing memory module (Main memory)

To install a memory module, make sure the computer is in boot mode then:
1. Turn the computer off in boot mode. Refer to the
section in Chapter 3, Getting Started.
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Chapter 6,
4. One screw in the position which removed the battery pack is removed,
and turn it right-side up.
8-6
mode.
Power and Power-Up
Figure 8-5 Removing a one screw
Turning off the power
Modes.)
User's Manual