Fan - Toshiba Tecra A2-S316 Maintenance Manual

4.14 Fan

4.14 Fan
Removing the Fan
The follo wing describes the procedure for removing the fan (See Figure 4-29).
1. Disconnect the fan cable from the connector on the system board.
2. Remove the following screws and remove the fan module by raising it up.
Installing the Fan
The following describes the procedure for installing the fan (See Figure 4-29).
1. Connect the fan cable to the connector PJ8770 on the system board.
2. Install the fan on the base assembly and secure it with the following screws.
Satellite A50/TECRA A2 Maintenance Manual (960-478)
M2.5x4B THIN BIND screw
Figure 4-29 Removing Fan Module
M2.5x4B THIN BIND screw
4 Replacement Procedures
x2
M2.5x4B THIN BIND
PJ8770
Fan Module
x2
4-41