Entone Amulet 200 Quick Reference Manual page 6

Hide thumbs Also See for Amulet 200:

Captioning is controlled by Amulet. To turn captioning on or off on decoder 1 either:

Press "LANG" button on the remote.

Use the User Menu.

NOTE: Control of captioning may vary for different service providers. For detailed usage of captioning,

please refer to the service provider.

11. Setting HDMI/Component Resolution

You can use User Menu or the Amulet front panel UP arrow to set the resolution. To use Amulet front

panel UP arrow to set resolution:

Press and hold the Amulet front panel "UP" arrow for 5 seconds.

Keep on pressing the "UP" arrow, the resolution indicator in the Amulet front panel display will

illuminate in a round robin manner from "1080i -> 720p -> 480p -> 480i".

When your desired resolution is illuminated, release the "UP" arrow. Then, both the HDMI and

Component outputs will be set to the selected resolution.

NOTE: If your TV does not display the video or error message is displayed after you have selected a

new resolution, your TV may not support the selected resolution. Repeat the above procedures again to

find a resolution supported by your TV.

NOTE: The S-Video, RCA Composite and TV OUT outputs are always set to 480i and will not be

affected by the HDMI and Component resolution setting.

Amulet Quick Reference (P/N 95-80xxxx-xx)

10. Captioning

Amulet