Advertisement
COPYRIGHT © © © © 2007 ENTONE, INC. ALL RIGHTS RESERVED
6. Programming Remotes For Use With Amulet
Amulet uses InfraRed (IR) to receive remote control signals. IR signals travel only short distances (40
feet or less), and cannot go through walls or other solid objects. You must point the remote control to the
Amulet, with no objects blocking the line of sight.
Your remote control by default is sending RF signals to STB. Do the following steps to program your
remote control to use IR signals to control Amulet.:
On the remote control, press and hold the "STB" button for approx. 5 seconds. The "STB" button
backlight will illuminate. Now the remote control is in registration mode.
On the URC PLUS, press "STB" once again. Both the "STB" and "AUX" button backlight will
illuminate.
Press "0" to set remote control to IR mode only.
The "STB" button backlight on the URC PLUS will blink twice to indicate that the setting was
successful. NOTE: Pressing a key other than "0" or a button is not pressed within 10 seconds, the
"STB" backlight will extinguish and the URC PLUS registration process will be terminated.
7. Manually Program Additional Devices
Perform the following steps to program the TV and AUX device:
Locate the device code for your desired device in the device code table provided in the Appendix. If
you could not find the device code for your device or it does not work after trying the listed device
codes for your device brand, then you can go to the next section to try the auto-search procedures.
Turn on your device and with media inserted (if applicable).
On the remote control, press a device mode key once (i.e., "TV" or "AUX"). NOTE: Use the "AUX"
mode key to program control of VCR, DVD player, cable box, satellite set-top-box and audio
device.
Press and hold the "SETUP" key until the selected mode key backlight blinks twice, then release
"SETUP". The device mode key will light up.
Enter the four-digit device code for you device. If you perform this procedure correctly, the selected
device mode key backlight will blink twice. NOTE: If you enter an invalid device code, the selected
device mode key will fast blink 7 times. Device program mode will be terminated.
Aim the remote control at your device and press the "POWER" once. The device should be turned
off. If it does not respond, repeat the above steps.
Amulet Quick Reference (P/N 95-80xxxx-xx)
.
4
Advertisement
