Replacing The Storage Drawer - GE JSP47, JSP57, JS968 Installation Instructions Manual

Installation Instructions
Installing The Range
I_ REPLACING THE OVEN DOOR
i
FAq
@
@
%
NOTE: The oven door is heavy. You
may need help lifting the door high
enough to slide it into the hinge slots.
Do not lift the door by the handle.
Lift the oven door by
placing one hand on
each side. The door
is heavy, so you may
need help. Do not lift
the door by the handle.
With the door at the same angle as
the removal position (halfway between
the closed and broil stop position),
seat the notch of the hinge arm into
the bottom edge of the hinge slot.
The notch of the hinge arm must be
fully seated into the bottom of the slot.
Bottom Edge
of Slot
Hinge Arm
Hinge Notch
Open the oven door as far as it
will open.
Push the hinge locks
Hinge
in
up against the front Locked Position
frame of the oven
cavity, to the
Notch of Hinge
locked
Securely Fitted
position,
into Bottom of
Hinge Slot
Close the oven door.
cont.
_-] REPLACING THE STORAGE
DRAWER
%
@
@
P,acethe
drawer rail
on the guides.
Push the
drawer in
until it stops.
Lift the front of the drawer and push in
until the stops clear the guides.
Lower the front of the drawer and
push in until it closes.
SPECIAL INSTRUCTIONS IF YOU ARE
HAVING PROBLEMS WHILE REPLACING
THE STORAGE DRAWER
If Drawer Won't Close:
Drawer front
Drawer does panel tipped
not close away from
completely J body side_l
Power cord _J J_ Rear drawer t I _
may be obstructing support is resting
drawer In this area i',_ on top of guide rail i_
Remove and replace, making sure the power
cord is not obstructing the drawer and/or the
rail is in the guide.
If Drawer Is Crooked:
Rear drawer
support is on Drawer front panel
top of guide rail
on the high side [_ tipped to one side
Remove and replace, making sure the rail is
in the guide.
13