Walking To A Destination; Adding A Stop (Via Point) To Your Route; Resetting The Nüvi; Taking A Detour - Garmin nüvi 800 Series Quick Start Manual

Taking a Detour

1. With a route active, select Menu.
2. Select Detour.
If the current route is the only reasonable
option, the nüvi might not calculate a detour.
You can also select specific detours while
navigating a route by using the Prompted
Detour feature. Select
navigation Prompted
>
navigating a route, touch
Menu page, and select a detour.
Adding a Stop (Via Point) to
Your Route
1. With a route active, select
Where to?.
2. Search for the extra stop (via point).
3. Select Go!.
4. Select Add as Via Point
before your destination. Select
new Destination
final destination.
tiP: To add more than one stop, edit the
current route. Select
tools > Settings
Detour. While
Detour
on the
Menu >
to add this stop
Set as
to make this your new
Where to? > routes.

Walking to a Destination

If you are walking to your destination, use
Pedestrian mode to optimize your route for
walking. Select
> Usage Mode
Securing Your nüvi
1. Select
>
2. Select
3. Enter a 4-digit PIN and drive to a security
location.
note: If you forget your PIN and your
security location, you must send your nüvi
to Garmin to get it unlocked. You must
also send a valid product registration or
proof of purchase.
Resetting the nüvi
If the nüvi screen stops functioning, turn the
nüvi off and on again. If this does not help,
Power
slide the
there for a minimum of 8 seconds. The nüvi
should operate normally.
You can also remove the battery, and then
reinstall it.

tools Settings
>
> Pedestrian
Tools > Settings > Security.
Garmin Lock.
key to the left and hold it
System
>
> oK.