Cleaning The Touch Panel Screen; Resetting Your Ique - Garmin iQue 3200 Operating Instructions Manual

Integrated handheld
Hide thumbs Also See for iQue 3200:
Table of Contents

Advertisement

Introduction: Performing a Reset

CLEANING THE TOUCH PANEL SCREEN

To clean the touch panel of the iQue 3200, wipe the surface gently with a soft, lint-free cloth. The cloth may be used either dry,
or dampened (not wet) with a mild detergent solution or with Ethanol.
WARNING: Never use acidic or alkaline detergents, or organic solvents such as paint thinner, acetone, tolu-
ene, xylene, propyl alcohol or kerosene on the touch panel.

RESETTING YOUR IQUE

You may need to perform a reset if your handheld no longer responds to the buttons or the screen. A soft reset allows your
handheld to get a fresh start, similar to rebooting a PC. All records and entries are retained after a soft reset.
To perform a soft reset:
1. Using the reset tip tool (that may be threaded into the head of your stylus) or an unfolded paper clip (or similar object
without a sharp tip), lightly press the Reset button inside the hole on the back panel of your handheld.
A hard reset will erase all records and entries stored in your handheld. Never perform a hard reset unless a soft reset does
not correct your problem. When you perform your next HotSync
synchronized to your computer.
To perform a hard reset:
1. With the unit powered off, use the reset tip tool to gently press and release the Reset button.
2. Press and hold down the power button until the Palm Powered
3. When the Palm Powered
4. When a message appears on the handheld screen warning that all data stored on the handheld is about to be erased,
do one of the following:
• Complete the hard reset by pressing the upper half of the scroll button on the front panel of the handheld. The
Digitizer screen appears.
• Press any other button to perform a soft reset.
NOTE: When you perform a hard reset, the current date and time are retained. Formats, preferences, and other
settings are restored to their factory default settings.
1.6
®
Stylus
logo is displayed, release the Power button.
Reset Button
Reset Tip Tool
®
operation, you can restore any data that you previously
logo is displayed.
Chapter 1 Introduction

Advertisement

Table of Contents
loading

Table of Contents