Install Vent System; Level Laundry Center; Make Gas Connection - Kenmore 24-inch wide laundry center washer-gas dryer Use And Care Manual

Recommended hood styles are shown here.
1
(1o.2 cm I
1, Louvered hood style
2. Box hood style
The angled hood style (shown following) is acceptable.
2.5"
See the exhaust vent length chart that matches your hood
type for the maximum vent lengths you can use.
Exhaust systems longer than specified will:
• Shorten the life of the dryer.
• Reduce performance, resulting in longer drying times and
increased energy usage.
3. Determine the number of elbows you will need.
IMPORTANT: Do not use vent runs longer than those
specified in the Vent Length Chart.
The chart below helps you determine your maximum vent
length based on the number of 90 ° turns or elbows you will
need and the type of vent (rigid or flexible metal) and hood
that you will use.
Vent Length Chart
Number of Type of Vent Box or Angled
90 ° turns Louvered hoods
or elbows hoods
0 Rigid metal 34 ft (12.2 m) 29 ft (10.7 m)
Flexible metal 21 ft (7.6 m) 16 ft (6.1 m)
1 Rigid metal 24 ft (9,7 m) 20 ft (8.2 m)
Flexible metal 15 ft (6.4 m) 10 ft (4.9 m)
2 Rigid metal 14 ft (7.3 m) 12 ft (5.8 m)
Flexible metal 7 ft (4.6 m) 2 ft (3.0 m)
NOTE: Side exhaust adds a 90 ° turn inside the laundry center. To
determine maximum exhaust length, add 1 90 ° turn to the chart.
1. (Optional) Put on safety glasses and gloves.
2. Install exhaust hood. Use caulking compound to seal exterior
wall opening around exhaust hood.
3. Connect vent to exhaust hood. Vent must fit inside exhaust
hood. Secure vent to exhaust hood with 4 in. (10.2 cm)
clamp.
4. Run vent to dryer location. Use the straightest path possible
(see "Determine Vent Length"). Avoid 90 ° turns. Use duct
tape to seal all joints.
Properly leveling your laundry center prevents excessive noise
and vibration.
1o Check the levelness of the laundry center by placing a level
on the top edge of the washer, first side-to-side, then front-
to-back.
2.
If the laundry center is not level, prop up the front with a
wood block and adjust the feet up or down as necessary.
Remove wood block and lower laundry center. Repeat this
step until the laundry center is level.
1. Remove the red cap from the flexible gas connector.
2. Remove the _f2in. NPT adapter from the flexible gas
connector, (it will be necessary to use two adjustable
wrenches).
3. Install the adapter on the V2in. rigid gas supply pipe using
pipe-joint compound.
2 _
:@
5 ...............
1. _/2in. rigid gas supply pipe
2. Use pipe joint compound
3. Y2in. NPT adapter
4. Do not use pipe-joint compound
5. Flexible gas connector
NOTE: For L.R gas connections, you must use pipe joint
compound resistant to the action of L.R gas. Do not use
TEFLON '_tape.
4. Attach the flexible gas connector to the _/;_ in. NPT adapter.
Do not use pipe-joint compound for this connection.
There should be a natural loop in the flexible gas connector.
The flexible gas connector must not be twisted, kinked or
attached with any sharp bends.
WRON•
13