Honeywell TE923W User Manual page 33

flash.
From the remote control: Press
Viewing Temperature and Humidity for each Channel
Static Display:
In Temperature and Humidity Mode, press the CHANNEL button to recall a different
channel.
Channel Auto-Scan Display:
To enable automatic scan of the different channels, press and hold CHANNEL, until the
icon is displayed. Each valid channel will be alternately displayed with a 5 seconds
delay.
Recalling of Temperature and Dew Point Displays
In Temperature and Humidity Mode press the SET button to recall temperature and
relative humidity or dew point and relative humidity.
Set the Temperature in Celsius or Fahrenheit.
In Temperature and Humidity Mode, press and hold SET to toggle the temperature in
Celsius (ºC) or Fahrenheit (ºF).
Activating/Deactivating the Temperature Alerts
In Temperature and Humidity Mode, press the ALARM/CHART to recall a current
temperature for the corresponding channel, the upper temperature alert with ▲icon (if
disabled, displays OFF), or lower temperature alert with ▼ icon (if disabled, displays
OFF).
Once the above alerts are displayed, press the UP or DOWN to enable or disable the
corresponding alert.
Programming the Temperature Alerts
•
In the Temperature and Humidity Mode, press ALARM/CHART selecting the
desired alarm.
•
Press and hold ALARM/CHART button until the remote temperature and ▲or
▼ icon starts flashing.
•
Adjust the temperature digits for the Temperature Alert using the UP or DOWN.
Press and hold either button for fast digits advance.
•
Press the ALARM/CHART to confirm selection and return to the temperature
alert selection screen.
.
33