2.
Lift the rear edge of the cover (2) up and forward until it rests at an angle.
3.
Remove the memory module/wireless module compartment cover. The memory module/wireless
module compartment cover is available in the Plastics Kit, spare part number 650478-001.
4.
Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The #1 WLAN antenna cable is connected to the WLAN module #1 terminal. The #2
WLAN antenna cable is connected to the WLAN module #2 terminal.
5.
Remove the two Phillips PM2.0×3.0 screws (2) that secure the WLAN module to the
system board. (The WLAN module tilts up.)
Component replacement procedures
45