Removing Procedure - Kenwood DNX7230DAB Quick Start Manual

Quick Start Guide
Microphone unit
1) Check the installation position of
the microphone (accessory 8).
2) Clean the installation surface.
3) Install the microphone.
4) Wire the microphone cable up to
the unit with it secured at several
positions using tape or other
desired method.
Fix a cable with a commercial item of tape.
Remove the separator of the
microphone, and stick the
microphone to the place shown
above.
Adjust the direction of the
microphone to the driver.
NOTE
• Install the microphone as far as possible
from the cell-phone.
8

Removing Procedure

Removing the trim plate
1) Engage the catch pins on the
extraction key (accessory 4)
and remove the two locks on the
lower level.
Lower the trim plate (accessory
5) and pull it forward as shown
in the figure.
NOTE
• The trim plate can be removed from the
top side in the same manner.
2) When the lower level is removed,
remove the upper two locations.
28
5
4
Catch
Lock