Garmin GPSMAP 496 Owner's Manual page 131
Garmin owner's manual portable aviation receiver gpsmap 496
Hide thumbs
Also See for GPSMAP 496:
- Owner's manual (196 pages) ,
- Quick reference manual (2 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
To have the unit automatically scan for a frequency:
1. With the unit set to GARMIN DGPS or RTCM In/NMEA Out, use
the ROCKER to highlight the Beacon field and press ENTER.
2. Highlight Scan, and press ENTER. The numbers in the
Frequency field change as the unit scans from 284 kHz to 325
kHz, 200 bit rate, then 100, at 6 second intervals.
Highlight Scan
and press
Enter
Interface tab of the Setup tab with GARMIN DGPS selected
GPSMAP 496 Owner's Manual
The Status field shows one of the following:
•
tuning—the unit is attempting to tune to the specified frequency
and bit rate.
•
Scanning—the unit is automatically scanning through the
frequencies and bit rates.
•
receiving—the unit is receiving DGPS signal and ready for
Shows the
operation.
status of the
scan
•
Check Wiring—the unit is not making connection with DGPS
receiver.
To restart the scan:
1. Press MENU.
2. Highlight Restart Scan, and press ENTER.
Main Menu >
Setup Tab
123
Advertisement
Table of Contents
