Garmin GPSMAP 496 Owner's Manual page 130
Garmin owner's manual portable aviation receiver gpsmap 496
Hide thumbs
Also See for GPSMAP 496:
- Owner's manual (196 pages) ,
- Quick reference manual (2 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Main Menu >
Setup Tab
•
garMin DgpS—used to connect the GPSMAP 496 with a
Garmin DGPS beacon receiver.
•
garmin remote Sonar—supports the input/output of a Garmin
remote sonar device.
•
nMEa in/nMEa out—supports the input/output of standard
NMEA 0183 version 3.01 data and sonar NMEA input support
for the DPT, MTW, and VHW sentences.
•
aviation in—the proprietary format used for connection to a
Garmin panel-mounted GPS receiver. Allows the GPSMAP 496
to show a Go To or route selected on the panel-mounted GPS
receiver. This eliminates the need to enter the destination on both
units.
•
aviation in/nMEa & VHF out—receives aviation data
and transmits out both NMEA data, at 9600 baud, and VHF
frequency tuning information to a Garmin Nav/Comm radio. See
page
147.
•
tiS in—receives TIS data from a Garmin Mode S transponder.
See
page
147.
•
tiS in/nMEa & VHF out—receives TIS data and transmits
out both NMEA data, at 9600 baud, and VHF frequency tuning
information to a Garmin Nav/Comm radio. See
•
rtCM in—allows Differential GPS (DGPS) input using a
standard RTCM format.
22
•
rtCM in/nMEa out—allows Differential GPS (DGPS) input
using a standard RTCM format and also provides NMEA 0183
version 3.01 output.
•
rtCM in/text out—allows Differential GPS (DGPS) input
using a standard RTCM format and also outputs simple text data
that includes, data, time, location, and velocity.
•
text out—allows the unit to output simple text data that
includes, data, time, location, and velocity. The Baud can be set
to 1200, 2400, 4800, or 9600.
•
none—provides no interfacing capabilities.
If you select GARMIN DGPS or RTCM In/NMEA Out format,
you can control a differential beacon receiver directly from your
GPSMAP 496 using the Interface sub tab. You can have the unit
automatically scan for the DGPS beacon signal, or you can enter
the beacon frequency and bit rate on the unit, and the information is
used to tune the beacon receiver. If you use a DGPS receiver, WAAS
capability is automatically turned off.
page
147.
GPSMAP 496 Owner's Manual
Advertisement
Table of Contents
