Garmin GPSMAP 396 Owner's Manual page 130

M M > s t
AIn enu etuP Ab
standard RTCM format.
• rtCM in/nMEa out—allows Differential GPS (DGPS)
input using a standard RTCM format and also provides
NMEA 0183 version 3.01 output.
• rtCM in/text out—allows Differential GPS (DGPS) input
using a standard RTCM format and also outputs simple text
data that includes, data, time, location, and velocity.
• text out—allows the unit to output simple text data that
includes, data, time, location, and velocity. The Baud can be
set to 1200, 2400, 4800, or 9600.
• none—provides no interfacing capabilities.
If you select GARMIN DGPS or RTCM In/NMEA Out format,
you can control a differential beacon receiver directly from your
GPSMAP 396 using the Interface sub tab. You can have the unit
automatically scan for the DGPS beacon signal, or you can enter
the beacon frequency and bit rate on the unit, and the information is
used to tune the beacon receiver. If you use a DGPS receiver, WAAS
capability is automatically turned off.
22
To have the unit automatically scan for a frequency:
1. With the unit set to GARMIN DGPS or RTCM In/NMEA Out,
use the ROCKER to highlight the Beacon field and press
ENTER.
2. Highlight Scan, and press ENTER. The numbers in the
Frequency field change as the unit scans from 284 kHz to
325 kHz, 200 bit rate, then 100, at 6-second intervals.
Highlight Scan
and press
Enter
Interface tab of the Setup tab with GARMIN DGPS selected
Shows the
status of the
scan
GPSMAP 396 Owner's Manual