Ignitor Lighting The Sideburner; Burner Flame Check; Turning Grill Off; Ignitor Check - Kenmore 415.167411 Assembly Instructions Manual

Match Lighting
• Do not lean over grill while lighting.
1.Open lid. Turn on gas at LP tank.
2. Place lit match into match lightinghole from outsidegdll
bottom (as shown).
3. Push in and turn RIGHT knob to HI. Be sure burner
lightsand stays lit.
4. Light other burners by pushingknobs Jnand turningto
HI.
After Lighting: Knobs remain on HI for warm-up.
-- Match lighting hole
Ignitor Lighting The Sideburner
1. Turn gas on at LP tank.
2. Push in and turnknob to HIGH.
3. Press ignitorbutton rapidly (_ for up
to 5 seconds. Be sure burnerlightsand
stayslit.
Match Lighting
1. Turn gas on at LP tank.
2. To light use any hole on sidebumer. Push in and turn
knob to HIGH. Be sure burner lights and stays lit.
Burner Flame Check
Lightburner, rotate knob(s)from HIGH to LOW.
You shouldsee a smallerflame in LOW
positionthan seen on . I_ ,_,, _ ,_,, _. HIGH
HIGH. Always check _ LOW
flame prior to each
use. Perform flame o ,_ _, o 8
checkfor sidebumer.If onlylow flame is seen refer to
"Sudden drop or low flame" in the Troub/eshooting Section.
Turning Grill Off
• Turnall knobs to OFF position.TurnLP tankOFF by turning
hand-wheel c lockwise t o a full stop.
WARNING
• If burner does not light turn knobs to OFF, wait 5
minutes, try again.
Ignitor Check
• Turn gas off at LP tank. Press Electronic Ignition button.
"Click" should be heard and spark seen each time between
collector box or burner and electrode. See "Troubleshooting"
if no click or spark.
Valve Check
• Important: Make sure gas is OFF at LP tank before
checking valves. Knobs lock in OFF position.To check
valves, first push in knobsand release, knobs shouldspring
back. If knobsdo not springback, replacevalveassembly
before usinggrill.Turn knobsto LOW position then turn back
to OFF position.Valvesshouldturn smoothly.
Hose Check
• Before each use, checkto see if hoses are cutor worn.
Replace damaged hosesbefore usinggrill. Use onlyvalve/
hose/regulator specified by manufacturer.
A CAUTION
• Clean burners prior to use after storing, at the beginning
of grilling season or a period of one month not being
used. Spiders and insects like to build nests in burner
tubes (especially during colder months). These nests
can cause fires in burner tubes or under grill.
Typical spider webs inside burner
• See followingpages for specific cleaning
instructions.
General Grill Cleaning
• Do not mistake brown or black accumulation of grease and
smokefor paint. Interiors of gas gritlsare not paintedat the
factory (and should never be painted). Apply a strong
solution of detergentand water or use a gdll cleanerwith
scrubbrushto insidesof gdll lid and bottom. Rinse and allow
to completelyair dry. Do not apply a caustic grill/oven
cleaner to painted surfaces.
Plastic parts: wash withwarm soapy water and wipe dry.
• Do not use citrisol,abrasivecleaners, degreasers or a
concentrated grill cleaneron plastic parts. Damage to and
failure of parts can result.
4638231 • 18