Engine Components - MULTIQUIP MP2050E1 Operation Manual

Honda GX270QWH2 Gasoline Engine
The engine (Figure 5) must be checked for proper lubrication
and filled with fuel prior to operation. Refer to the
manufacturers engine manual for instructions & details of
operation and servicing.
1. Fuel Tank/Fuel Filler Cap – Holds unleaded gasoline.
For additional information refer to engine owner's
manual. Remove this cap to add unleaded gasoline to
the fuel tank. Make sure cap is tightened securely. DO
NOT over fill.
DANGER - Explosive Fuel Hazard
Adding fuel to the tank should be done
only when the engine is stopped and
has had an opportunity to cool down.
In the event of a fuel spill, DO NOT
attempt to start the engine until the
fuel residue has been completely wiped up, and the
area surrounding the engine is dry.
2. Throttle Lever – Used to adjust engine RPM speed
(lever advanced forward SLOW , lever back toward
operator FAST ).
3. Engine ON/OFF Switch – ON position permits engine
starting, OFF position stops engine operations.
4. Recoil Starter (pull rope) – Manual-starting method.
Pull the starter grip until resistance is felt, then pull
briskly and smoothly.
5. Fuel Valve Lever – OPEN to let fuel flow, CLOSE to
stop the flow of fuel.
6. Choke Lever – Used in the starting of a cold engine,
or in cold weather conditions. The choke enriches the
fuel mixture.
7. Air Cleaner – Prevents dirt and other debris from
entering the fuel system. Remove wing-nut on top of
air filter cannister to gain access to filter element.
MQ MP2 MASONRY SAW — OPERATION MANUAL — REV. #2 (3/12/13) — PAGE 19
MP2 MASONRY SAW — GASOLINE ENGINE COMPONENTS
Figure 5. Engine Controls and Components
NOTE
8. Spark Plug – Provides spark to the ignition system.
Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch)
Clean spark plug once a month.
9. Muffler – Used to reduce noise and emissions
DANGER - Burn Hazard
Engine components can generate
extreme heat. To prevent burns, DO
NOT touch these areas while the engine
is running or immediately after
operating. NEVER operate the engine
with the muffler removed.
10. Oil Level Cap and Dipstick – Check engine oil with
engine stopped and in a level position.
11. Oil Drain Bolt – Drain used oil while the engine is warm.
Operating the engine without an
air filter, with a damaged air filter,
or a filter in need of replacement
will allow dirt to enter the engine,
causing rapid engine wear.