4092-001
3. Diagnostic Aids
Use these diagnostic test procedures to verify a repair. There are
two ways to enter test procedures, each procedure will indicate the
method to use:
Procedure 1:
•
Press and hold the Paper Feed
printer on. Release the button when the printer completes
POST.
Procedure 2:
•
Turn the printer off.
•
Use a two pin jumper on connector J6.
•
Turn the printer on. The test begins when the Power Button is
pressed.
A two pin jumper is also available in the parts packet,
13B0239.
button while turning the
Diagnostic Aids 3-1