Base Assembly Removal; Carrier Belt Removal - Lexmark 7000 Color Jetprinter Service Manual

4092-001

Base Assembly Removal

1. Remove the front cover.
2. Remove the rear cover.
3. Disconnect the power supply connector at the system board.
4. Remove the two screws from the maintenance station assem-
bly. Pull up the right side of the mid frame assembly and pull for-
ward and remove the maintenance station assembly.
5. Remove the two screws securing the carrier frame to the base
cover.
6. Slide the printer off the base cover.

Carrier Belt Removal

1. Remove the front cover.
2. Remove the printhead carrier assembly.
3. Push the idler pulley to the right to release the tension on the
belt and remove the belt.
Note: When reinstalling the carrier belt, place the carrier at the
center position between the tabs on either end of the belt.
4-3