GE JKS10 Installation Instructions Manual page 5

Installation instructions
Cutoutfor 27"(68.6
Ovensonly
For JKP35, JKP55, JKP75, PK956, ZEK958 models only.
Allow 1" (2.5 cm)
for overlap of
oven over side
edges of cutout
5"
(12.7 cm)
Max. from
the left or
Cabinet right
(68.6 cm) _
Cutout
5" (63.5 cm) Min.
25 1/4" i
(s4.1cm) M_,
20" (50.8
--_ j°s-
.... Ailo_v I "
(2,5 cm) for
Allow a minimum
of 20" (50.8 cm)
for clearance to
adjacent corners,
drawers, walls, etc.
when door is open
i Junction Box
__ Location
(111.8 cm)
Min.
icut°ut Above
iHeight base rail
i49 11116"
i(126.2 cm) IVlin.
150 118"
i(127.3 cm) Max.
Recommended
cutout location
overlap of oven from floor 13 114"
top and bottom_ (33.7 cm)
of cutout
Cabinet Width
Recommended
Cutout Location
from Floor
Cutout Depth
Cutout Width
Cutout Height
27" (68.6 cm)
13 1/4" (33.7 cm)
23 5/8" (60 cm) Min.
25" (63.5 cm) Min.
25 114" (64.1 cm) Max.
49 11116" (126.2 cm) Min.
50 1/8" (127.3 cm) Max.
NOTE: If the cabinet does
not have a front frame and
the sides are less than 314"
(1.9 cm) thick, shim both
sides equally to establish
the cutout width.
if the cabinet does not have a solid bottom,
two braces or runners must be installed to
support the weight of the oven. For double
ovens, the runners and braces must
support 300 Ibs (135 Kg).
-- 2" x 4"
(ScmxtOcm)
or equiva|ent
ruuners level
with bottom
of cutout
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are
covered.
Suitable
Bracing
to Support
Runners
Over Centerline
of Cabinet
5