GE JKS10 Installation Instructions Manual page 4

Installation instructions
Cutout for 27" (68.6 c )Single
Ovens on y
For JKS10, JKP30, JKP70, PK916, ZEK938 models only.
uilt-ln
Allow 1" (2.8 era)
for overlap of
oven over side
edges of cutout
2" x 4"
(Scmx tOcm)
0¥
runners level
with bottom
of cutout
20" (50.8 era)
" Allow"
1" (2.5 cm)
Allow a minimum
minimum for
ciearance°f 20" (50.8teCta),41 _ for overlap of
a_jacen, oven top and
corners, drawers, wails, bottom
etc. when door is open of cutout'_"'_--_
5" (12.7 cm)
Max. from the
left or right
Cabinet_ _sk !_ Junction Box
/ Location
I
27" (68.6 cm) i
Cutout Width /_
25" (63.5 cm)
Min. j ,, : ,,
25 114" (64.1 "!-'
Max.
Cutout
Height 22" (55.9 cm)
27 5/8" Min. above
(70.2 cm) Min. base rail
28 118" I
Box Location - access from
adjacent cabinet
Recommended may be required
cutout location
from Roor 32 1/2"
(82.6 cm)
Cabinet Width
Recommended
Cutout Location
from Floor
Cutout Depth
Cutout Width
Cutout Height
27" (68.8 cm)
32 1/2" (82.6 cm)
23 1/2"
(59.7 cm) Min.
25" (63.5 cm) Min.
25 1/4" (64.1 cm) Max.
27 5/8" (70.2 cm) Min.
28 1/8" (71.4 cm) Max.
NOTE: if the cabinet does not
have a front frame and the sides
are less than 3/4" (1.9 cm) thick,
shim both sides equally to
establish the cutout width.
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. For
single ovens, the runners and braces
must support 150 Ibs (68 Kg).
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are
covered,
2" x 4" (5 cmx tO cm) or
equivalent runners love|
with bottom of cutout
T
24"
(61 cm)
1
I-'_- 18" (45.7 cm) "-_1
"_ 27" (68,6 cm) "_
These ovens are not approved for
stackable installations.
4