GE JKS10 Installation Instructions Manual page 10

Installation instructions
Allow 11116"
(1.75 cm) for
overlap of oven .__
over side edges
of cutout
Allow a minimum
of 21" (53.3 cm) for
clearance to adjacent
corners_ d rawers_
walls, etc. when
door is open
\
21" (53.3 cm)_
Cutout for 30"(76.2 cm)
Ovensonly
For JTP35, JTP55, JTP75, PT956, PT960, ZET958 models only.
Cutout
Width
28 1/2" (72.4 cm)
Min. -,_
28 5/8" (72.7 cm)
Max.
Between I
Inside Walls I
Must Be At
Least 28 1/2"
(72.4 cm) Wide
AHow 1" (2.5 cm)
minimum for
overlap of oven
top and 11/4"
9 1/2"
(24.1 cm) Junction Box
_t Location
(junction box
may be
located in
adjacent
n cabinet)
/"
Cutout
Height
51 13/16" 131.6 cm)
Min.
51 15/16" (131.9 cm)
47" (119.4 cm)
Min.
to Bottom of
Junction Box
(3 2 cm) over ap Max
of oven bottom - I
ofcutout " F - _-I
/1 Recommended
--_ 30_ I cutout location
(76.2 cm)"_;,_from f!oor 12" (30.5 cm)
Cabinet _'_..L,_.
Width I
if the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. For
double ovens, the runners and braces
must support 275 Ibs (124 Kg).
Suitable
Bracing --
to Support
Runners
Cabinet Width
Recommended
Cutout Location
from Floor
Cutout Depth
Cutout Width
Cutout Height
30" (76.2 cm)
12" (30.5 cm)
23 1/2" (59.7 cm) Min.
28 1/2" (72.4 cm) Min.
28 5/8" (72.7 cm) Max.
51 13/16" (131.6 cm) Min.
51 15116" (131.9 cm) Max.
NOTE: If the cabinet does not
have a front frame and the sides
are less than 314" (1.9 cm) thick,
shim both sides equally to
establish the cutout width.
-- 2"x4"
(Scm xtOcrn)
or equiva|eut
runners
|eve|
with bottom
of cutout
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are
covered,
10