Thread Reel Change On Threaded Machine - Pfaff Hobbylock 784 Instruction Manual

Threading the right needle
Threading of guide wires 18 and of the
thread guide behind the carrying handle
is shown on page 7.
In the left-hand illustration the threading
path is shown from the green tension (1>
up to the right needle (6>. At point 5 the
thread must be pulled behind the thread
retainer.
Threading the left needle
Threading of guide wires 18 and of the
thread guide behind the carrying handle
is shown on page 7.
In the left-hand illustration the
threading path is shown from the blue
tension (1) up to the left needle (6>.
At point 5 the thread must be pulled
behind the thread retainer.
.1
H— •f? 3 111.3
rrc 2
—3
5
•L!J
:'1i
:
Ll
rk
Thread spool change on threaded machine
Cut the threads close to the thread spool. Place new thread spools on spool holders 17.
Tie the threads still in the machine and the new threads together. Pull the needle threads
out of the needles. Now pull at the thread ends until the knots are about 15 cm past the
last thread guide before the needles. Cut the knots
off
and pull the threads through the
respective needle eyes. The looper threads can be pulled until past the looper eyes without
interruption. Pull about 10 cm of thread through the looper eye.
10