Daikin FTXS30HVJU Operation Manual page 25

WEEKLY TIMER Operation
NOTE
WEEKLY TIMER
•
Do not forget to set the clock on the remote controller fi rst.
•
The day of the week, ON/OFF time can be set with WEEKLY TIMER. For ON-TIMER, settings other than the above are based on the remote
controller settings just before the operation.
•
Both WEEKLY TIMER and ON/OFF timer cannot be used at the same time. The ON/OFF timer has priority if it is set while WEEKLY TIMER is still
active. WEEKLY TIMER is activated after the reserved ON/OFF timer is completed.
•
The activates or deactivates the reservation.
•
To set WEEKLY TIMER, press
•
Only the time and set temperature set with the weekly timer are sent with the
Set the weekly timer only after setting the operation mode, the fan strength, and the fan direction ahead of time.
•
Up to 4 settings per day and up to 28 settings per week can be reserved with WEEKLY TIMER. If a reservation deactivated with
activated once again, the last reservation mode will be used.
•
Shutting the breaker off, power failure, and other similar events will render operation of the indoor unit's internal clock inaccurate. Reset the clock.
Page 9
•
The can be used only for the mode, time and temperature settings.
It cannot be used to go back to the reservation number.
24
6.
Press to select the desired time.
• The time can be set between 0:00 and 23:50 in 10 minute intervals.
• Press to return to the mode setting.
9
• Go to STEP if "OFF" is selected at STEP
7.
Press
• The time will be set.
" • " and the temperature blink.
8.
Press to select the desired temperature.
• The temperature can be set between 50°F (10°C) and 90°F (32°C).
Cooling: The unit operates at 65°F (18°C) even if it is set at 50 (10) to 63°F (17°C).
Heating: The unit operates at 86°F (30°C) even if it is set at 88 (31) to 90°F (32°C).
• To return to the time setting, press
• The set temperature is only displayed when the mode setting is on.
9.
Press
• The temperature will be set and go to the next reservation setting.
• To continue further settings, repeat the procedure from STEP
10.
Press
• Point the remote controller toward the air conditioner and press the buttons to operate. The air
conditioner will beep and the operation lamp will fl ash.
" • " is displayed on the LCD.
• The TIMER lamp lights up.
Control panel
Page 9
and make a reservation according to the procedures.
4
.
.
.
.
to complete the setting.
.
2
.
is