Preparation Before Operation; C/F Display Switch; Set Batteries - Daikin FTXS15HVJU Operation Manual

Preparation before Operation

2
Position
–
correctly!
3
1
Set. Pull.
Remote controller
holder
ATTENTION
About batteries
•
When replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.
•
When the system is not used for a long time, take the batteries out.
•
The batteries will last for approximately 1 year. If the remote controller display begins to fade and the degradation of reception performance occurs
within a year, however, replace both 2 batteries with new, size AAA.LR03 (alkaline).
•
The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
About remote controller
•
Never expose the remote controller to direct sunlight.
•
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
•
Signal communication may be disabled if an electronic-starter-type fl uorescent lamp (such as inverter-type lamps) is in the room. Consult the shop
if that is the case.
•
If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.
Celsius/Fahrenheit display change function of remote controller
•
The set temperature may increase when the display is changed to Celsius from Fahrenheit, because a fraction of 0.5°C is rounded up.
•
Example: A set temperature of 64°F (equivalent to 18.5°C) will be converted into 19°C.
When the display is changed to Fahrenheit again, the set temperature will be converted into 66°F (equivalent to 19°C) instead of the
original set temperature (64°F) but a set temperature of 66°F (equivalent to 19°C) will be converted into 19°C with no temperature change.
•
A reception sound will go off for the transmission of set temperature to the indoor unit at the time of setting the Celsius/Fahrenheit display change function.
8
To set the batteries
1.
Slide the front cover to take it off.
+
and
2.
Set 2 dry batteries AAA.LR03 (alkaline).
3.
Set the front cover as before.
To fi x the remote controller holder on the wall
1.
Choose a place from where the signals reach
the unit.
2.
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
3.
Place the remote controller in the remote
controller holder.
Celsius/Fahrenheit display switch
• The Celsius or Fahrenheit display is selectable with the following buttons.
Press
for 5 seconds.
• The temperature will be displayed in Fahrenheit if it is presently displayed in Celsius, and
vice versa.
and buttons simultaneously