Advertisement
Tighten screws as follows:
v Plastic to plastic
Turn an additional 90 degrees after the screw head
touches the surface of the plastic part:
v Logic card to plastic
Turn an additional 180 degrees after the screw head
touches the surface of the logic card:
v Torque driver
If you have a torque driver, refer to the "Torque" column
for each step.
v Make sure you use the correct screw. If you have a
torque screwdriver, tighten all screws firmly to the torque
shown in the table. Never use a screw that you
removed. Use a new one. Make sure the screws are
tightened firmly.
2
90 degrees more
(Cross-section)
180 degrees more
(Cross-section)
Advertisement
