Operating Instructions; Getting Started - Electrolux EIDW5705PB0A Use & Care Manual

Operating Instructions
GET NG 'TARTED
To run your dishwasher, follow these
OFT' ON SELECTIONS
basic steps:
Hi-Temp Wash
1 Load dishwasher. (See Preparing and
Loading Dishes)
2 Add detergent. (See Dishwasher Dispenser &
Detergents)
3 Add rinse aid, if needed. (See Rinse Aid)
4 Select desired CYCLE. (See Cycle Selections).
The touchpads are illuminated white
when selected.
5
6
Select desired OPTIONS. (See Energy Options
Selections). The touchpads are
illuminated white when selected.
To start, press START/CANCEL pad and close
door. (See Start/Cancel)
When HI-TEMP WASH option is selected, the dish-
washer heats water in the main wash to approxi-
mately 140oF(60oC).
This increase in water temperature helps dish-
washer detergent remove food grease and soil from
dishes more effectively and aids in drying. This
option is available in NORMALWASH and LIGHT
WASH. HI-TEMP WASH is automatically provided
when HEAVY WASH cycle is selected.
Sanitize Option
To sanitize your dishes and glassware, select the
SANITIZE option. When selected, the light above the
pad will come on. The water temperature in the
final rinse will be raised to 155°F (68°C) assuring
bacteria is destroyed. This option is available in
HEAVY WASH, NORMAL WASH and LIGHT WASH.
Only these sanitization cycles have been designed to
meet NSF requirements.
WASH CYCLE SELECTIONS
Cycle times are approximate and will vary with
options selcted. Hot water is necessary to activate
dishwasher detergent and melt fatty food soils. An
automatic sensor will check the incoming water
temperature and, it it is not hot enough, the timer
will be delayed for automatic water heating in the
main wash of all cycles. This happens even when
HI-TEMP WASH option has not been selected. When
HI-TEMP WASH is selected, an even higher tempera-
ture will be guaranteed to handle heavier soil loads.
The cycle time will be extended until the proper
water temperatures are reached. Washing action
will continue during the water heating delay. For
best results, the incoming water temperature should
be at least 120°F (49°C).
The sanitize criteria may not be satisfied if there is
an interruption of the cycle, power failure or if the
incoming water temperture is below 120°F (49°C).
To turn off the SANITIZE option, press the pad a
second time. The light above the pad will turn off.
To Cancel a Cycle
You can cancel a cycle anytime during the cycle.
Press START/CANCEL pad and the dishwasher will
start a 60 second drain. At the end of the drain,
select the desired cycle.
When an option is selected, the light above the pad
will come on and remain on until end of cycle. To
turn off the option, press the pad a second time.
The light above the pad will turn off.
iiiiiiiiii_iiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiii_iiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiii_iiiiiiiiiii