Tractor Set-Up - Cub Cadet CLT 160 Operator's Manual

SECTION 7: TRACTOR SET-UP
NOTE:
Reference to RIGHT or LEFT side of the
tractor in this manual is observed from operator's
position.
ATTACHING THE BATTERY CABLES
NOTE:
The battery cables may or may not be
attached on your unit. If the cables are not attached,
please follow the instructions below.
NOTE:
The positive battery terminal is marked Pos.
(+). The negative battery terminal is marked Neg. (–).
• The positive cable (heavy red wire) is secured to
the positive battery terminal (+) with a hex bolt and
hex nut at the factory. Make certain that the rubber
boot covers the terminal to help protect it from
corrosion.
• Remove the hex bolt and wing nut from the
negative cable.
• Remove the black plastic cover, if present, from the
negative battery terminal and attach the negative
cable (heavy black wire) to the negative battery
terminal (–) with the bolt and wing nut.
• Make certain the battery retainer rod is in position
over the battery, securing it in place. See Figure 1.
Rubber
Boot
Positive
Terminal
Wing
Nut
Negative
Terminal Shoulder Bolt
Figure 1
NOTE:
If the battery is put into service after the date
shown on top of battery, charge the battery as
instructed on page 23 of this manual prior to operating
the tractor.
Battery
Battery
Retainer Rod
ATTACHING THE STEERING WHEEL
In the event your tractor was crated with the steering
wheel and the seat removed for shipping reasons, use
the following instructions to properly assemble the
parts.
WARNING:
without first attaching both the steering
wheel AND the seat. Doing so could result
in serious injury to the operator.
NOTE:
There are two different styles of steering
wheel cap. See Figure 2. Styles vary by model.
• Using your hands, place the tractor's front tires in
position for straight-ahead travel.
• Remove the steering wheel cap from the center of
the steering wheel. Be careful not to lose the hex
screw and bell washer found beneath it.
• Place the steering wheel (in position for straight-
ahead travel) directly onto the steering shaft found
in the center of the tractor's dash.
• Place the bell washer (cupped side DOWN) over
the steering shaft.
• Thread the hex screw into the steering shaft and
tighten securely.
Reinsert the steering wheel cap in the center of the
•
steering wheel. Refer to Figure 2
Steering
Wheel Cap
Hex Bolt
& Washer
8
Do NOT operate the tractor
.
Steering
Shaft
Figure 2