Maintenance - Cub Cadet CLT 160 Operator's Manual

Hex Nut
Set Gap
at 0.011"
Brake Disc
NOTE:
View shown from beneath tractor.
Figure 17
STEERING ADJUSTMENT
If the tractor turns tighter in one direction than the
other, or if the ball joints are being replaced due to
damage or wear, the steering drag links may need to
be adjusted.
Adjust the drag links so that equal lengths are
threaded into the ball joint on the left side and the ball
joint on the right side:
• Loosen the jam nut found on the drag link at the
rear of the ball joint. See Figure 18.
• Remove the hex nut and lock washer on the top of
ball joint. See Figure 18.
• Thread the ball joint toward the jam nut to shorten
the drag link. Thread the ball joint away from the
jam nut to lengthen the drag link.
Replace hex nut and lock washer and retighten the
jam nut after proper adjustment is achieved.
SECTION 11: MAINTENANCE
WARNING:
maintenance or repairs, disengage PTO,
move shift lever into neutral position, set
parking brake, stop engine and remove key to
prevent unintended starting.
CLEANING THE ENGINE AND DECK
Any fuel or oil spilled on the machine should be wiped
off promptly.
Do NOT allow debris to accumulate around the cooling
fins of the engine or on any other part of the machine,
especially the belts and pulleys.
IMPORTANT:
The use of a pressure washer or
garden hose to clean
recommended. It may cause damage to electrical
components, spindles, pulleys, bearings or the engine.
The use of water will result in a shortened life of the
tractor and reduce its serviceability.
Compression
Spring
Transmission
Before performing
your tractor is
Hex Nut and
Lock Washer
Axle
NOTE:
Threading the ball joints too far onto the drag
links will cause the front tires to "toe-in" too far. Proper
toe-in is between 1/16" and 5/16".
Front tire toe-in can be measured as follows:
• Place the steering wheel in position for straight
ahead travel.
• In front of the axle, measure the distance
horizontally from the inside of the left rim to the
inside of the right rim. Note the distance.
• Behind the axle, measure the distance horizontally
from the inside of the left rim to the inside of the
right rim. Note the distance.
• The measurement taken in front of the axle should
be between 1/16" and 5/16" less than the
measurement taken behind the axle.
• Adjust if necessary.
Deck Wash System (Optional)
any
Your tractor's deck is equipped with water ports on its
surface as part of its deck wash system.
Use the Deck Wash System™ to rinse grass clippings
from the deck's underside and prevent build-up of
corrosive chemicals. Complete the following steps after
each mowing:
IMPORTANT:
chute is directed away from your house, parked cars,
etc.
1. Drive the tractor to a level, clear spot on your lawn,
near enough to a water sillcock (spigot) for your
garden hose to reach.
NOT
2. Disengage PTO, move shift lever into the neutral
position, set the parking brake, and stop engine.
3. Thread the hose coupler (packaged with this
manual) onto the end of your garden hose.
20
Zerk Fitting
(if so equipped) Pivot Bar
Drag Link
Jam Nut
Ball Joint
Figure 18
Make certain the tractor's discharge