Routing Setup - EnGenius ESR350 User Manual

Routing Setup

Typically static routing does not need to be setup because the router has adequate routing information after it has been configured
for Internet access. Static routing is only necessary if the router is connected to network under a different subnets.
To view the Routing settings, click Advanced then select Routing.
Note: To enable a static routing, NAT must be disabled.
If the router is connected with a network under the different
subnet, the routing setup allows the network connection within
two different subnets.
Enable Static Routing
Click Enable Static Routing to activate the feature.
Destination LAN IP
Enter the LAN IP address of the destination device.
Subnet Mask
Enter the Subnet Mask of the destination device.
Default Gateway
Enter the default gateway IP address for the destination device.
Hops
Enter the maximum number of hops within the static routing
that a packet is allowed to travel.
Interface
Select LAN or WAN as the interface.
Click Add to save the settings and list the configuration in the
Current Static Routing table or Reset the discard changes.
View and select devices in the Current Static Routing Table.
Click Delete Selected or Delete All to remove devices
from the table. Click Reset to stop.
Click Apply to save the settings or Cancel to discard changes.
121