Location Requirements; Electrical Requirements - KitchenAid DVM-1815 Installation Manual

3. The water shut-off should be located in the base cabinet on
either side of the refrigerator. The right-hand side is
recommended. The access hole through the right cabinet
must be within in. (12.7 mm) of rear wall.
4. A in. (12.7 mm) hole for plumbing should be within the
bottom shaded area (see the "Connect Water Line to
Refrigerator" section). Water line can be through floor or wall.
If the recommended water line location is used, no additional
plumbing needs to be purchased.
1
80" - 90"
(203-229 cm)
1
83 / " (211.5 cm) min.
4
84 3 / " (215 cm) max.
4
to bottom of solid soffit.*
(see chart following)
3" (7.6 cm)
(28 cm)
23 1 / "
2
(60 cm) min.
1. Stud location
2. Grounded electrical outlet location
3. Recommended water shutoff valve location
4. Plumbing hole and water line location (wall or floor)
Width of Opening:
Model
36 in. (91.4 cm)
42 in. (106.7 cm)
48 in. (121.9 cm)
6
4"
(10.2 cm)
77"
(196 cm)
A
Width
6"
(15.2 cm)
11"
6"
6"
(15.2 cm)
(15.2 cm)
Width A (as shown above)
35 in. (90.2 cm)
41 in. (105.4 cm)
47 in. (120.7 cm)

Location Requirements

2
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion,
or fire.
NOTES:
Do not install the refrigerator near an oven, radiator, or other
heat source, nor in a location where the temperature will fall
below 55°F (13°C).
Floor must support refrigerator weight, more than 600 lbs.
[272 kg], door panels and contents.
Ceiling height must allow for side or front tipping radius (see
the "Tipping Radius" section).
Location should permit doors to open fully. See the "Door
Swing Dimensions" section.

Electrical Requirements

WARNING
3
Electrical Shock Hazard
4
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection:
WARNING
Explosion Hazard