Kenmore 141.16226 Owner's Manual page 11

Installing Lighting Stick
Attach the Lighting Stick to the Left Bowl
Support Bracket as shown in Figure 7.
Align the hole at the end of Lighting Stick
Wire with the threaded hole on the Left Bowl
Support Bracket. Tighten securely using the
M4x8mm Pattern Head Screw packed with the
Liqhtinq Stick.
Installing Grease Tray
1. Attach the Grease Tray Bracket on the
Grease Tray. Secure firmly using two 1/4"xl/2"
Pattern Head Screws. See Figure 8. Repeat
this step on the other side.
Pattern Head Screw 1/4"xl/2"
Ref.#S132G04082
Figure 7
Pattern Head Screw M4x8mm
Ref.#S 132M04082
Figure 8
GREASE TRAY
GREASE TRAY BRACKET
LEFT OUTSIDE
BOWL PANEL
M4xSmm PATTERN
HEAD SCREW _\
LIGHTING STICK
GREASETRAYBRACKET
_GREASETRAY
2. From the back side of Grill Head, install the
Grease Tray. See Figure 9.
Figure 9
GRILL BOWL _
• When you have finished assembling your
Grill be sure all Pattern Head Thumb Screws
are tightened. You may use the supplied
Tightening Tool as needed.
J
J
GREASE TRAY
11