Buick 2014 Regal Infotainment System Manual page 60

Hide thumbs Also See for 2014 Regal Infotainment System:
Table of Contents

Advertisement

In general there are flexible ways to
speak commands for completing the
tasks. Most of them, except
destination entry and voice keypad,
can be completed in a single
command. If the task takes more
than one command to complete, the
first command would be to indicate
the kind of task to be performed, like
Navigation Destination Entry. The
system replies with prompts that
lead you through a dialog to enter
the necessary information. For
example, if a destination for route
guidance is needed, say
Navigation or Destination Entry.
Voice recognition can be used when
the ignition is on or when Retained
Accessory Power (RAP) is active.
See Retained Accessory Power
(RAP) in the owner manual.
Voice recognition becomes available
once the system has been
initialized. This begins when the
ignition is turned on. Initialization
may take a few moments.
1. Press
on the steering wheel
control to activate voice
recognition, or press
infotainment touchscreen on the
center stack.
If voice recognition is
started from the steering
wheel control, the
instrument cluster displays
the selections and visual
dialog content.
If voice recognition is
started from the
infotainment touchscreen
on the center stack, the
selections and visual dialog
content are displayed on
both the center stack
display and the instrument
cluster display.
2. The audio system mutes and the
system plays a prompt followed
by a beep.
3. Wait until after the beep
completes, then clearly speak
one of the commands described
on the
in this section.
A voice recognition system
prompt can be interrupted while
it is playing by pressing
For example, if the prompt
seems to be taking too long to
finish, press
beep should happen right away.
There are two voice prompt modes
supported:
Long verbal prompts: The longer
prompts provide more
information regarding the
supported actions.
Short prompts: The short
prompts provide simple
instructions about what can be
stated.
If a command is not spoken, the
voice recognition system says a
help prompt.
again.
again and the

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents