Simulator Mode - Garmin Fishfinder 100 Owner's Manual

Simulator Mode

The Fishfinder 100 comes with a built-in simulator mode that will
allow the user to practice and learn the operation of the unit at home rather
than on the water.
To start the simulator mode, turn the unit on without a transducer
installed. As the unit powers on, the unit will indicate that it is running the
simulator mode by displaying a message across the bottom of the chart.
The message will be replaced by the simulator mode icon in the lower left
corner of the chart. While in the simulator mode, the unit will display a
random bottom scene and the Fishfinder 100 can be controlled just as if it
were on the water.
The unit can be configured to act as if a variety of transducers are
installed while in the simulator mode.
To Select a Specific Transducer:
1. Press the Setup button on the face of the unit.
2. Using the arrow keys, highlight the 'Tools' tab then the 'Simulator'
selection field.
3. Press ENTER. Choose the desired transducer from the list.
4. Press ENTER to accept the transducer selection.
To exit the Simulator, turn the unit off.
On the Water
Simulator Mode
Simulator Message and Icon
Simulator Transducer Selections
33