Checking Propeller - Yamaha 70 Owner's Manual

Maintenance
1. Tilt support lever
5. Check that the tilt rod and trim rods are
free of corrosion or other flaws.
6. Activate the tilt-down switch until the trim
rods have retracted completely into the
cylinders.
7. Activate the trim-up switch until the tilt
rod is fully extended. Unlock the tilt sup-
port lever.
8. Tilt the outboard motor down. Check
that the tilt rod and trim rods operate
smoothly.
NOTE:
Consult your Yamaha dealer if any operation
is abnormal.
EMU29171

Checking propeller

EWM00321
WARNING
You could be seriously injured if the en-
53
gine accidentally starts when you are
near the propeller.
Before inspecting, removing, or install-
G
ing the propeller, remove the spark
plug caps from the spark plugs. Also,
place the shift control in neutral, turn
the main switch to "
move the key, and remove the lanyard
from the engine stop switch. Turn off
the battery cut-off switch if your boat
has one.
Do not use your hand to hold the pro-
G
peller when loosening or tightening the
propeller nut. Put a wood block be-
tween the anti-cavitation plate and the
propeller to prevent the propeller from
turning.
Checkpoints
Check each of the propeller blades for
G
wear, erosion from cavitation or ventila-
" (off) and re-
ZMU01896
ZMU01897