Tilting Up And Down - Yamaha F6 Owner's Manual

Operation
also be adjusted to help offset this effect.
When the bow of the boat is down, it is easier
to accelerate from a standing start onto plane.
Bow Up
Too much trim-out puts the bow of the boat
too high in the water. Performance and econ-
omy are decreased because the hull of the
boat is pushing the water and there is more air
drag. Excessive trim-out can also cause the
propeller to ventilate, which reduces perfor-
mance further, and the boat may "porpoise"
(hop in the water), which could throw the op-
erator and passengers overboard.
Bow Down
Too much trim-in causes the boat to "plow"
through the water, decreasing fuel economy
and making it hard to increase speed. Operat-
ing with excessive trim-in at higher speeds
also makes the boat unstable. Resistance at
40
the bow is greatly increased, heightening the
danger of "bow steering" and making opera-
tion difficult and dangerous.
NOTE:
Depending on the type of boat, the outboard
motor trim angle may have little effect on the
trim of the boat when operating.
EMU27933

Tilting up and down

If the engine will be stopped for some time or
if the boat is moored in shallows, the outboard
motor should be tilted up to protect the propel-
ler and casing from damage by collision with
obstructions, and also to reduce salt corro-
sion.
EWM00220
WARNING
Be sure all people are clear of the out-
board motor when tilting up and down,
also be careful not to pinch any body parts
between the drive unit and engine bracket.
EWM00250
WARNING
Leaking fuel is a fire hazard. If there is a
fuel joint on the outboard motor, discon-
nect the fuel line or close the fuel cock if
the engine will be tilted for more than a few
minutes. Otherwise fuel may leak.