Table of Contents
Advertisement
Installing the optional
fax modem
3-4
7. When the installation is complete, the Installation Complete screen
will be displayed.
8. Click Close.
To install the optional Kodak Scan Station Fax Modem Accessory
(CAT No. 128 0528):
NOTES:
• Before installing the optional fax modem accessory, verify that you
are running Version 2.0 or greater. Go to www.kodak.com/go/
disupport for more information about updating.
• The Kodak Scan Station Fax Modem Accessory is only available on
the Scan Station 100 and Scan station 100 Plus with serial numbers
higher than (or equal to): 45325000 and Scan Station 120EX's with
serial numbers higher than (or equal to) 45334500.
1. Plug in the standard RJ-11 phone line into the phone connector port
on the front of the modem. Be sure the other end of the phone line is
connected to your fax line outlet.
2. Plug in the USB connector to the back of the modem.
3. Plug the other end of the USB connector into the back of the Scan
Station.
NOTE: The USB connectors on the back of the Scan Station may
be covered by a black rubber plug. Remove this plug to
expose the two USB ports (located below the ethernet
port).
A-61588 July 2008
Advertisement
Table of Contents
