Machine Troubleshooting - Windsor chariot iExtract CE24 Operator Instructions Manual

MACHINE TROUBLESHOOTING

PROBLEM
Vacuum motor(s) not running, or run
slowly
Vacuum shoes will not go up/down
Poor scrubbing performance
Little or no solution flow to the floor
Brush motors do not run, or run
slowly
Scrub deck will not go down/up
4-24
CAUSE
Circuit breaker tripped
Faulty vacuum circuit or switch
Worn vacuum motor brushes
Faulty cables or pulleys
Debris caught in scrub brushes
Worn brushes
Low scrub brush down
pressure
Low battery charge
Solution tank empty
Solution pump turned off
Solution strainer plugged
Solution system plumbing
obstructed
Pump obstructed
Solution solenoid valve
obstructed or stuck
Solution Shut-off valve is
closed
Jet(s) obstructed
Faulty pump circuit or pump
Faulty solenoid
Circuit breaker(s) tripped
Low battery charge
Faulty brush circuit or motor
Worn brush motor brushes
Actuator circuit breaker tripped
Faulty actuator circuit or
actuator
86037880 CHARIOT EXTRACTOR 01/14/08
SOLUTION
Reset circuit breaker
Check wires, connections and switch
Replace brushes, check commutator
Repair/replace cables and pulleys
Remove debris
Replace brushes
Increase brush pressure
Charge batteries
Fill solution tank
Turn on pump
Clean solution strainer
Clear obstruction from plumbing
Clean or replace pump
Clean or replace valve
Open shut-off valve
Clean or replace jet(s)
Check wiring, connections, and pump.
Check solenoid valve
Reset circuit beaker(s) and check
brush pressure.
Charge battery
Check wires, connections and motor
Replace brushes, check commutator
Reset breaker
Check wires, connections and actuator