Introduction; Key Operation Flow - Toshiba B-SX6T SERIES System Mode Manual

1. INTRODUCTION

1. INTRODUCTION
This document describes key operations using the keys and LCD display on the printer that you can operate
on a printer alone. Key operations are performed in the following four printer setting modes:
• Online mode where a pause, reset, automatic threshold setting, etc. are performed.
Download mode where a firmware downloading is performed.
•
System mode for service personnel where a self-diagnosis, printer parameter settings, RAM clear, IP
•
address setting etc. are performed.
System mode for end user where a self-diagnosis, printer parameter settings, fine adjustment, etc.,
•
which are same functions as those in System mode for service personnel, are performed.
NOTE: This document uses the B-SX8T for examples of the display.

1.1 Key Operation Flow

Power OFF
Turn the power on.
Online
[FEED] key
[PAUSE] key
While holding down the [FEED],
[RESTART], and [PAUSE] keys,
turn the power on.
While holding down the [FEED] and [RESTART]
keys, turn the power on.
While holding down the
[FEED] and [PAUSE]
keys, turn the power on.
Online mode
Feeds one label.
Pause
Hold down the [PAUSE] key
for a few seconds.
Hold down the [RESTART] key
for a few seconds.
Download mode
System mode for service personnel
• Self-test
• Parameter setting
• Fine adjustment
• Test print
• Sensor adjustment
• RAM clear
• IP Address setting
• Basic setting
• For factory
• RFID Module Setting
[RESTART] key
Feed gap sensor automatic threshold setting
[FEED] key or [RESTART] key
Black mark sensor threshold setting
• Reset
• Parameter Setting
• Fine adjustment
• Dump mode
• Expand mode (Basic expansion mode)
• Automatic calibration mode
• LAN Enable/Disable
• RTC Setting
• Self-test
• Parameter setting
• Fine adjustment
• Test print
1- 1
(Revision Date: Jul. 24, 2008)
1.1 Key Operation Flow
System mode for end users
EO13-33002