Tuner Operation; Preset Stations - Jensen DV2011 Installation And Operation Manual

TUNER OPERATION

7 1 6 4 10
COMP ACT
DIGITAL AUDIO
MUTE MUTE
LOUD
MODE MODE LOC
EQ
BAND BAND
INT
1 2
5 3 19 8 9 12 13
Select a Band
Press the BAND button (19) on the control panel (or the SOURCE button on the remote control)
to change between three FM bands and two AM bands. Each band stores up to six preset
stations.
Tuning
Manual Tuning
Press the up >>| (20) or down |<< button (21) for less than three seconds to enter seek tuning
mode. Press the up >>| or down |<< button to change the radio frequency number up or down
one step.
If using the remote control, press the TUNE + or TUNE - buttons to change the radio frequency
number up or down one step.
Auto Seek Tuning
Press the up >>| (20) or down |<< button (21) for more than three seconds to move to the next
station automatically.

Preset Stations

Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Press and hold a preset button (12-17) for three
seconds. The preset number will appear in the display.
24 23 2 20
DV2011
MP3
WMA
RPT RDM
3 4 5 6 A/PS DISP
AV IN AV IN
14 15 16 17 11 18 22 21
Recall a Station
Select a band (if needed). Press a preset button (12-17) to select the corresponding stored
station.
Automatically Store / Preset Scan
Automatically Store
Select a band (if needed). Press A/PS (11) for more than three seconds to automatically select
six strong stations and store them in the current band. The new stations replace any stations
already stored in that band.
Preset Scan
Select a band (if needed). Press A/PS (11) to scan stations stored in the current band. The unit
will pause for ten seconds at each preset station. Press A/PS again to stop scanning when the
desired station is reached.
Stereo
The unit will automatically pick up a stereo signal, when available. When in stereo mode, the "
icon appears in the display. When no stereo signal is available, the unit will automatically revert to
mono operation, and no icon will be displayed.
12
DV2011
"