Connecting The Am (Mw) And Fm Antennas; Connecting A Tv - JVC TH-D51 Instructions Manual

Getting started
Connecting the AM (MW) and FM
antennas
Make sure the antenna conductors do not touch any
other terminals, connecting cords or power cords.
Keep the AM loop antenna cable wrapped around
the AM loop antenna frame, otherwise the
effectiveness and sensitivity of the AM loop antenna
may be reduced.
AM (MW) loop
antenna (supplied)
FM antenna
(supplied)
Extend it horizontally.
For better FM reception
FM outdoor antenna
Standard type (75 Ω
coaxial) connector (IEC
or DIN 45325)
7
Turn it until the best
reception is obtained.
(not supplied)
FM outdoor antenna cord
(not supplied)

Connecting a TV

Connect the TV to the appropriate video out jacks to view
the playback picture.
Make the following settings after connecting the TV:
– Scanning mode (
– Monitor out ( 13)
– MONITOR TYPE (
Connection using the HDMI terminal
From HDMI input
terminal
TV
HDMI cable (not supplied)
You can make the following settings for the TV when
the HDMI connection is used:
– HDMI DVI COLOR (
– HDMI OUT ( 23)
– HDMI AUDIO OUT (
– DOWN MIX ( 24)*
Use a certified HDMI cable, which has the HDMI
logo.
You can use a monitor with a DVI terminal by
connecting with a DVI-HDMI conversion cable.
When you play HDCP (High-Bandwidth Digital
Content Protection) source, allow a few seconds for
the sound and picture to be transmitted to the
speakers and TV while the confirmation process is
completed.
On some TVs, no sound may come out during
playback of sources such as DVD Audio even when
the HDMI AUDIO OUT setting is "ON" (
*
This setting is available only when the speaker position
mode is set to "S.SPK F" (
12)
23)
23)
24)
24).
11).