Using The Setup Wizard - Cisco Small Business RV215W Quick Start Manual

Using the Setup Wizard

4
The Setup Wizard and Device Manager are supported on Microsoft
Internet Explorer 6.0 or later, Mozilla Firefox 3.0 or later, and Apple Safari 3.0
or later. To configure the firewall by using the Setup Wizard:
Power on the PC that you connected to the LAN1 port in
S 1
TEP
the Connecting the Equipment
client of the firewall and receives an IP address in the 192. 1 68. 1 .xxx
range.
Launch a web browser window on your PC.
S 2
TEP
In the address bar, enter the default IP address of the firewall,
S 3
TEP
192. 1 68. 1 . 1 . A site security certificate message displays. The
Cisco RV215W uses a self-signed security certificate. This
message appears because the firewall is not known to your PC.
Click Continue to this website (or the option shown on your
S 4
TEP
particular web browser) to continue. The login displays.
Enter the username and password. The default username is cisco.
S 5
TEP
The default password is cisco. Passwords are case sensitive.
Click Log In. The Router Setup Wizard starts.
S 6
TEP
Follow the on-screen instructions to set up your firewall. The
S 7
TEP
Router Setup Wizard tries to automatically detect and configure
your connection. If it is unable to do so, it might ask you for some
information about your Internet connection. Contact your ISP to
obtain this information.
Change the password as instructed by the Router Setup Wizard or
S 8
TEP
follow the instructions the
and Password
device with the new username and password.
The Getting Started page of the Device Manager appears. It
displays the most common configuration tasks.
Click one of the listed tasks or a task listed in the navigation bar to
S 9
TEP
complete the configuration.
Save any additional configuration changes and log out of the
S 10
TEP
Device Manager.
Cisco RV215W Wireless-N VPN Firewall
Changing the Administrator Username
section to do so. You are required to log into the
section. Your PC becomes a DHCP
Step 3 of
5