Run The System Setup Wizard - Cisco S190 Quick Start Manual

Run the System Setup Wizard

14
At the prompt, run the systemsetup command.
Step 3
The System Setup Wizard starts automatically when you access the appliance via
the web-based interface and displays the end user license agreement (also known
as the EULA).
Accept the end user license agreement.
Step 1
Enter information from the
Step 2
page 4.
If you need additional information about the settings, choose Help and
Support > Online Help.
Review the configuration summary page.
Step 3
Click Install this Configuration.
Step 4
The appliance may not appear to have accepted your configuration or
Step 5
be performing the installation. This is because you have changed the IP
address, but the installation is underway.
If you temporarily changed the IP address of your computer as
Step 6
described above, change the IP address settings back to the original
values.
Ensure that your laptop and the appliance are connected to the
Step 7
network.
Log in to the appliance again, at the hostname or IP address that you
Step 8
noted in the "Plan the Installation" section on page
admin and the new password that you entered in the wizard.
The Cisco M390 Content Security Management Appliance uses a
self-signed certificate that may trigger a warning from your web
browser. You can simply accept the certificate and ignore this warning.
Be sure to keep your new administrator password in a safe place.
Step 9
"Document Network Settings" section on
6. Use the username