Air Connection; Control Layout - Central Pneumatic 43760 Assembly And Operating Instructions Manual

For best service you should incorporate a regulator and inline filter, as shown in the diagram
above. Hoses, couplers, regulators, and filters are all available at Harbor Freight Tools.
Note: Compressor pumps discharge condensed water, oil, or other contaminants along with
the compressed air. Condensation causes "fish eyes" to appear in paint patterns. To avoid
this problem, install water/oil removal filters and controls (not included) as close to the Spray
Gun as possible. If run through the Gun, water and oil will cause damage.
1. You will need to prepare a 1/4" air connector (sold separately) to connect to the air inlet
on the Spray Gun. First, wrap the 1/4" air connector (not included) with pipe thread seal
tape before threading it into the Air Inlet (34). Connect the 3/8" ID Air Source Hose to
the Spray Gun.
2. Set the air pressure on your compressor to 20-55 PSI. Do not exceed the maximum air
pressure of 55 PSI.
3. Check the air connection for leaks and then disconnect the tool from the air source.
FIGURE 1
Air Cap Set (1)
Trigger (32)
For technical questions, please call 1-800-444-3353;
SKU 43760

Air Connection

Control Layout

Cup (43)
Troubleshooting section at end of manual.
Pattern Control Knob (14)
Fluid Control
Knob (15)
Air Inlet (34)
Page 6