Advertisement
Appliance description
q
Laser appliance
ON/OFF button
w
Spirit level for horizontal lines
e
Spirit level for vertical lines
r
Laser lens
t
y
Rotating plate with degree scale
u
Marking arrow
Fastening pins
i
Fixing points on the laser appliance
o
Fixing points on the rotating plate
a
Battery compartment
s
(on the rear side)
Inserting the batteries
1. Open the battery compartment
2. Insert two batteries of Type AAA/LR03
into the battery compartment
with the polarity markings in the battery
compartment
s
3. Close the battery compartment
Utilisation
Switching On and Off
1. To switch the laser appliance
press the ON/OFF
2. To switch the laser appliance
press the ON/OFF
again.
Utilisation on a wall
1. Remove the laser appliance
the rotating plate. The laser appliance
clings to the rotating plate
cally.
2. Place the rotating plate
tion on the wall from where you wish
to draw the alignment line.
s
.
s
. Comply
.
s
.
q
on,
w
button.
q
off,
w
button once
q
from
y
magneti-
y
at the posi-
3. Secure the rotating plate
in that you take both fastening pins
from the sides of the appliance and you
press them through the fixing points on
the rotating plate
(See Fig.
).
Notice:
The fastening pins
into most upper surfaces, such as wood,
plaster or mortar. Alternatively, espe-
cially with other upper surfaces, you
could also use adhesive tape for secu-
ring the rotating plate
You can also secure the laser appliance
q
without the rotating plate, in that
the fastening pins
through fixing points on the laser
appliance
o
4. Place the laser appliance
rotating plate
5. Turn the laser appliance
marking arrow
direction.
6. Switch the laser appliance
pressing the ON/OFF button
The laser beam appears on the wall in the
direction of the marking arrow
Plumb-line
To mark a plumb-line, turn the laser
appliance
q
with the marking arrow
the direction in which the laser marking
is to be indicated, then finely adjust it
vertically with the spirit level
- 2 -
y
to the wall
a
and into the wall
i
can be inserted
y
.
i
are inserted
itself.
q
onto the
y
.
q
with the
u
into the desired
q
on, by
w
.
u
.
on the rotating plate
u
pointing in
r
.
i
y
Advertisement
