Maintenance And Servicing; Metal Drilling; Wood Drilling - Drill Master 3670 Set Up And Operating Instructions Manual

bend or break and may damage the work
piece.
5. Back off your pressure when you are
about to penetrate the work piece.
6. Keep the motor running when pulling the
bit out of a completed hole to prevent the
bit from jamming.

Metal Drilling

1. Use high speed steel, carbide or
specialty bits for metal drilling.
2. Secure the work piece to keep it from
moving during the drilling operation.
3. Use a punch to create a dimple for the
bit to start.
4. Start by drilling slowly to keep bit from
moving away from your starting point.
5. As the hole is established, increase tool
speed. Do not go so fast or use so much
pressure that the bit heats up. This can
damage the bit and create an irregular
hole. For hard metal or thick pieces, use
cutting oil to keep the bit cool.
6. Since drilling in metal is a slow operation,
you may lock the Trigger in the ON
position to maintain a constant speed
and reduce fatigue.
7. When drilling large holes in metal, start
by drilling a smaller pilot hole, then using
a larger bit for the final size hole.

Wood Drilling

1. Use high carbon bits or bits specially
designed for wood drilling, such as brad
point, spade bits, forstner bits, etc.
2. Secure the work piece to keep it from
moving during the drilling operation.
SKU 3670 For technical questions, please call 1-800-444-3353.
3. Start by drilling slowly to keep the bit
from moving away from your starting
point. Increase speed as the hole is
established.
4. To prevent or reduce "break out" when
the bit penetrates the work piece, clamp
a piece of scrap material to the back of
the work piece.
5. Do not lock the Trigger in the ON
position, as the bit can easily jam in
wood and the motor must be stopped
quickly.
MAIntEnAncE AnD
SERVIcIng
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
tO PREVEnt
SERIOuS InjuRY
FROM AccIDEntAL
OPERAtIOn:
turn the Power Switch of the tool
off and unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, cleaning
procedures, or removing/
attaching bits.
tO PREVEnt SERIOuS InjuRY
FROM tOOL FAILuRE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
cleaning, Maintenance, and
Lubrication
1. BEFORE EAch uSE, inspect the
general condition of the tool. Check for
Page 10