Table of Contents
Advertisement
#11 Ignition OFF Unlock #2: Default ON (LOCK).
#12 Open Door Bypass To Previous Three Features: Default ON (LOCK).
#13 Confirmation Chirps: Default ON (LOCK).
#14 Confirmation Chirps In Valet Mode: Default OFF (UNLOCK).
#15 Activated Alarm Cycle: Default 60 Seconds (LOCK).
#16 Lights On Upon Disarm: Default 30 Seconds (UNLOCK).
#17 Disarm Alarm Upon Trunk Release: Default ON (LOCK).
#18 Doorlock Pulse Time: Default .8 second (LOCK).
#19 Two Unlock Pulses: Default OFF (UNLOCK).
#20 Arming Delay: Default 3 Seconds (LOCK).
#21 Pulsed Horn / Steady Siren Output: Default Pulsed Horn (LOCK).
#22 Horn Chirp Loud or Soft: Default Loud (LOCK).
#23 Total Closure Lock Output: Default OFF (UNLOCK).
#24 Alarm Functions Bypass: Default OFF (UNLOCK).
#25 Ignition-Activated Anti-Carjacking Protection: Default OFF (UNLOCK).
#26 Door-Activated Anti-Carjacking Protection: Default OFF (UNLOCK).
#27 Open Door Warning Upon Arming: Default OFF (UNLOCK).
#28 PANIC Button Operates "Panic" or Additional Output: Default Panic (LOCK).
The following pages explain each feature in detail, and the centerfold pages of
this guide contain a checklist designed to assist in the programming of features.
resumes, and the "stage 2" entry, nine presses must be entered, which achieves an
override and disarms the system. However, if either entry is incorrect, the system
will not disarm. Another override attempt may be made, but two consecutive incor-
rect entries will cause the system to ignore any further attempts for two minutes. If
a customized valet switch entry is desired for the Selectable Code Override, please
note that the "stage 2" is optional; either the first stage only may used, or both the
first and second stages.
To custom program the Selectable Code Override from the default setting, follow
Steps 1, 2, and 3 on pages 25-26. At Step 4, press and release the
transmitter's LOCK button a number of times equal to the desired Selectable Code
Override for stage 1. The system will respond to each transmitter button press with
a horn chirp. After pressing the transmitter button the desired number of times, wait
for the system to chirp the horn an equal number of times. Now press and release
the transmitter's UNLOCK button a number of times equal to the desired Selectable
Code for stage 2. The system will again chirp the horn in the same fashion as the
code entered for stage 1. Should the system have an unknown customized Select-
able Override Code already entered, the factory-set default of one press and
no press can be obtained by resetting the system: on the bottom of the system
control module is small round access opening with two solder contacts visible be-
low. Use a small slotted screwdriver to short the solder contacts together until the
system responds with a brief sounding of the horn, indicating a successful reset.
Page - 28
Page - 30
Programmable Features
#1 Selectable Code Override: Default 1 & 0. The valet switch is an important
part of your Model One system; it allows an emergency override to disarm the sys-
tem in place of the remote transmitter, and it is crucial to the programming of trans-
mitters and features. Your Model One's advanced design includes this program-
mable feature, which allows you to configure the valet switch operation for the most
convenient ease of use, or for personally-customized maximum security.
The Selectable Code Override must be entered as part of three of the Model
One's operations: to achieve an override disarming of the system, to access Trans-
mitter Programming Mode and Features Programming Mode. For a more secure
access to these operations, the vehicle owner may select the number of valet switch
presses, from 1 to 9 presses, which are needed to achieve the successful entry of
the Selectable Code Override. Additionally, this customized number of valet switch
presses may be "single stage" or "double stage".
As an illustration of this feature, with the default setting of "one and no presses",
to disarm the system without the transmitter, after entering the vehicle, the ignition
switch is turned "on", and the valet switch is pressed once, at which the system will
instantly disarm. With a custom-programmed Selectable Code Override of, for ex-
ample, "3 and 9 presses", upon entering the vehicle and turning the ignition "on",
the valet switch must be pressed three times. This causes the audible output (i.e.-
horn or siren) to stop sounding and emit one chirp. The audible output then
#2 Last Door Arming: Default OFF. This feature automatically arms the system
upon your exiting the vehicle, and is explained in detail on pages 7-8. If desired,
having the doors lock when the system automatically arms may added to this feature's
operation. The Last Door Arming feature is independent of the Automatic Rearming
Feature.
#3 Automatic Rearming: Default OFF. This feature ensures that your Model
One is always armed. It is possible, on occasion, to accidentally and unknowingly
disarm the system by having an object press the transmitter button while in a pocket
or purse. If this feature is programmed to operate, the system will automatically
rearm itself 90 seconds after being disarmed, unless the ignition switch is turned
"on" or a door is opened. Also, if feature #7 (Doors Lock With Automatic Rearming)
is utilized, the doors will also lock upon the system automatically rearming.
In daily operation, upon disarming the system, Automatic Rearming is confirmed
by a fast flashing LED status light. Once the ignition switch has been turned "on",
the system will stay disarmed condition until it is armed again from the transmitter or
by Last Door Arming. Opening a door will also stop Automatic Rearming; it will be
cancelled completely if Last Door Arming is off, and temporarily suspended while the
door is open if Last Door Arming is turned on.
#4 Starter Interrupt Circuit: Default ON. This feature controls the starter inter-
rupt circuit, which operates if this feature is on. Programming this feature off turns off
the starter interrupt output, leaving all other system operations fully functional.
Page - 29
Page - 31
Advertisement
Table of Contents
