Explanations Of Menu Items - Oki ML3310e Help Manual

Explanations of Menu Items

7 or 8 Bits Data Word (ML). If your computer system uses
seven bits to make up each unit of data, change this setting
to 7.
7 or 8 Bit Graphics. Choose the graphics your system
uses: 7 or 8 dots in each column printed.
Auto CR (IBM). If you want the printer to automatically
add a carriage return when a Line Feed is received at the
end of a line, change the setting to Yes.
Auto LF. If your printout is consistently double spaced,
select No; if it overprints, select Yes.
Auto Feed XT (Epson). If your system uses pin 14 of the
parallel interface to control automatic line feed, change
the setting to Valid.
Auto Select. If you always use the same Top of Form
position, change the setting to Yes.
Bottom Margin. Change to Invalid if you want the printer
to ignore the bottom margin setting. Caution! This can
cause loss of data and damage the printhead.
Centring Position. Choose DEFAULT, Mode 1 or Mode 2.
Help Guide
Character Set. Choose IBM Set I or IBM Set II.
Code Page. Choose the Code Page character set you wish
to use: USA (IBM 437), CyrillicI-855, CyrillicII-866,
Windows Cyrillic, or Ukrainian.
Draft Mode. Change to SSD if you wish to use the Super
Speed Draft mode of printing. Note: Print Mode must be
set to DRAFT for this setting to be effective.
Emulation Mode. Choose the printer emulation.
Form Tear-Off. Choose 500 mS, 1 sec, or 2 sec to turn
the Form Tear-Off feature on and to set the time interval
for the printer to wait before advancing the paper.
Graphics. Change to bidirectional graphics for faster
printing: optimise the registration using the Print
Registration menu item.
I-Prime. Determines what the printer will do when it
receives the I-Prime signal from the host: Buffer Print
prints out the buffer contents before resetting; Buffer Clear
dumps the buffer contents immediately. Invalid causes
the printer to ignore the I-Prime signal.
19