Oki Microline 320 User Manual page 8

2. Next install the sheet stacker.
Put the stud of one of the stacker's legs into the
hole at the end of the rear vent. Gently press the
other leg until it slips into the other hole.
3. Make sure the power switch is OFF. Plug the
power cord into the back of the printer. Plug the
other end into an earthed socket.
4. Turn the power switch on, and check that the
POWER lamp and the ALARM lamp are
illuminated. If paper is loaded, the POWER
lamp and the SEL lamp will be illuminated.
E – 7